14
15
14
15
ADJUSTING THE VISE (FIG. G)
NOTE:
The vise of your saw is used
to secure the workpiece during cutting
operations.
1. Rotate the handle (1)
counterclockwise to allow enough
room for the workpiece to fit
between the vise clamp (2) and the
adjustable fence (3).
2. Position the workpiece between the
vise clamp (2) and the adjustable
fence (3). Turn the handle (1)
clockwise to clamp the workpiece
securely.
3. The vise incorporates a quick
release locking lever (4). To use the
quick release feature, lift up on the
quick release locking lever (4) and
slide the vise clamp in or out to the
desired position.
4. When vise clamp (2) is in desired
location, flip the quick release
locking lever (4) down to engage
the threads with the threads of the
vise. Begin to turn the handle (1)
clockwise to secure the workpiece
within the vise.
Fig. G
3
2
4
1
ADJUSTING FOR ANGLE CUTTING
(FIG. H)
1. Loosen the vise handle and back
the vise clamp (2) away from the
adjustable fence (3).
2. Loosen the two bolts (1) of the
adjustable fence with a 17 mm wrench.
3. Move the adjustable fence (3) to
the desired angle between 0 and 45
degrees.
4. Tighten the two bolts (1).
5. The vise clamp (2) will align itself
automatically with the angle of
the workpiece when clamping a
workpiece in position.
Fig. H
INSTALLING AND ADJUSTING
THE EXTENSION WING AND STOP
BLOCK (FIG. I, J)
1. Attach the stop block (1) into the
extension tube (2). (Fig. I)
2. Loosen the locking screw (3) with
the Phillips screwdriver.
3. Insert the extension tube (2) into the
mounting holes (4) located on the right
side of the metal cutter base. (Fig. J)
4. Thread the stop screw (5) and into
the end of the extension tube (2).
5. Adjust the extension tube (2) to the
desired position.
6. Tighten the locking screw (3).
0 15
30
45
1
3
2
