8
9
8
9
●
KEEP HANDS AWAY FROM
CUTTING AREA.
Keep hands
away from blade. Do not reach
underneath work or around or under
the blade while the blade is rotating.
Do not attempt to remove cut
material while blade is moving.
●
NEVER USE IN AN EXPLOSIVE
ATMOSPHERE.
Normal sparking of
the motor or sparking from cutting
metal could ignite fumes.
●
DO NOT USE TOOL IF SWITCH
DOES NOT TURN IT ON AND OFF.
Have defective switch replaced by
an authorized service center.
●
KEEP TOOL DRY, CLEAN AND
FREE FROM OIL AND GREASE.
Always use a clean cloth when
cleaning. Never use brake fluids,
gasoline, petroleum-based products
or any solvents to clean tool.
●
ALWAYS SUPPORT LONG
WORKPIECES.
To minimize risk of
tipping the saw, always support long
workpieces.
●
BEFORE MAKING A CUT, BE
SURE ALL ADJUSTMENTS
ARE SECURE. ALWAYS USE
THE VISE CLAMP
to secure the
workpiece.
●
NEVER TOUCH BLADE
or other
moving parts during use.
●
NEVER START THE METAL
CUTTER WHEN THE BLADE IS IN
CONTACT WITH THE WORKPIECE.
●
NEVER
cut more than one
workpiece at a time.
●
DO NOT STACK
more than one
workpiece on the machine base at a
time.
●
NEVER PERFORM ANY
OPERATION FREE-HAND
. Always
secure the workpiece to be cut in
the vise.
●
NEVER
hand hold a workpiece.
Workpiece will become very hot
while being cut.
●
NEVER
reach behind, under or
within 7.6 cm of the blade and its
cutting path with your hands and
fingers for any reason.
●
NEVER
reach to pick up a
workpiece, a piece of scrap or
anything else that is in or near the
cutting path of the blade.
●
MAKE SURE THE BLADE
IS SECURELY MOUNTED
as described in the operating
instructions before connecting
the tool to a power supply. Do not
tighten blade excessively, since this
can cause cracks.
●
CHECK THE BLADE FOR
FISSURES AND CRACKS
, and test
for normal operation prior to use.
●
ALWAYS EASE THE SAW BLADE
AGAINST THE WORKPIECE
when
starting to cut. A harsh impact can
break the blade.
●
ONLY USE A METAL CUTTER
BLADE RATED FOR 1300 RPM
OR GREATER
and manufactured in
compliance with ANSI B 7.1. Always
store blades in a dry place with little
temperature variation.
●
BEFORE CUTTING
, press the
trigger switch and allow the blade to
reach full speed.
●
This metal cutter has been designed
for cutting metals, using reinforced
abrasive metal cutter blades only.
Do not remove the blade, install
a steel blade and attempt to cut
other types of materials such as
wood, masonry, etc. Attempting to
cut these other types of materials
could cause an accident resulting in
serious personal injury.
●
Do not attempt to modify this
tool or create accessories not
recommended for use with this tool.
Any such alteration or modification
is misuse and could result in a
hazardous condition leading to
serious personal injury.
