2
Important Directions for Use
2.1
Appropriate Use
2.1.1
Introduction
Rexroth products reflect the state-of-the-art in their development and their
manufacture. They are tested prior to delivery to ensure operating safety and
reliability.
Personal injury and property damage caused
by incorrect use of the products!
WARNING
The products have been designed for use in industrial environments and may
only be used in the appropriate way. If they are not used in the appropriate
way, situations resulting in property damage and personal injury can occur.
Rexroth as manufacturer is not liable for any damages resulting
from inappropriate use. In such cases, the guarantee and the
right to payment of damages resulting from inappropriate use are
forfeited. The user alone carries all responsibility of the risks.
Before using Rexroth products, the following pre-requisites must be met to
ensure appropriate use of the products:
●
Personnel that in any way, shape or form uses our products must first
read and understand the relevant safety instructions and be familiar with
their appropriate use.
●
If the products take the form of hardware, then they must remain in their
original state, in other words, no structural changes are permitted. It is
not permitted to decompile software products or alter source codes.
●
Damaged or faulty products may not be installed or put into operation.
●
Make sure that the products have been installed in the manner descri‐
bed in the relevant documentation.
2.1.2
Areas of Use and Application
Drive controllers made by Rexroth are designed to control electrical motors
and monitor their operation.
Control and monitoring of the Drive controllers may require additional sensors
and actors.
The drive controllers may only be used with the accessories and
parts specified in this documentation. If a component has not
been specifically named, then it may neither be mounted nor con‐
nected. The same applies to cables and lines.
Operation is only permitted in the specified configurations and
combinations of components using the software and firmware as
specified in the relevant Functional Descriptions.
Drive controllers have to be programmed before commissioning to ensure
that the motor executes the specific functions of an application.
Drive controllers of the Rexroth IndraDrive line have been developed for use
in single- and multi-axis drive and control tasks.
DOK-INDRV*-SYSTEM*****-PR06-EN-P
Rexroth IndraDrive Drive Systems with HMV01/02 HMS01/02, HMD01, HCS02/03
Bosch Rexroth AG
35/309
Important Directions for Use
