7
Move the mouse to highlight
Configuration
then select
RF Settings
.
The RF Settings page, above, must be configured correctly for the Antenna to find Satellites.
Check the LNB specifications on the LNB Label attached to the Feed Assembly of the Antenna.
You should find LNB Voltage, LO Frequency, and RF Bandwidth.
If the LNB is Dual Band see
Advanced LNB Settings in Detailed Configuration Information later in this document.
➢
IF LNB Volts gives a range of 12VDC to 24VDC, use the 18 V LNB Power option
➢
22KHz Tone = Disabled
➢
DiSEqC = Disabled
➢
Enter LO Freq in MHz (example 10.75GHz = 10750 MHz) see above
➢
Enter RF Band Low Freq (example 11.70~12.20 GHz = 11700) see above
➢
Enter RF Band High Freq(example 11.70~12.20 GHz = 12200) see above
IMPORTANT!
Polarity must stay
HORIZONTAL
. Do not change this setting.
See H-V Field Detail
in Detailed Configuration Information later in this document.
After all changes are completed re-verify the modifications and then select the APPLY located in
the top right of this page. The system should return to the Main Status Page after updating.
