RF Neulink
31
NL6000 User Guide
6.2.
Radio Network Setup
Setting the Unit Type
1.
Select
Network
Unit Type
.
2.
Select from the following options:
1-Base
Configure as a base station. This unit type receives the
TOID from the data packet received through the serial
port.
2-Remote
Configure as a remote. This unit type receives the
TOID from its configuration.
Setting the Unit ID (MYID)
1.
Select
Network
MYID
.
2.
Enter a unique identification for the unit. The value must be a
hexadecimal value between 0001 and FFFE. For more information
about addressing and wildcards, refer to Section 5.4.
Setting the Target Unit ID (TOID)
You only need to set this parameter if the
Unit Type
is
Remote
. The system
ignores this parameter if the
Unit Type
is
Base
.
1.
Select
Network
TOID
.
2.
Enter the destination address for packets from this unit. The
destination address is the MYID of the unit for which the data is
intended. The value must be a hexadecimal value in the range 0000 –
FFFF. For more information about addressing and wildcards, refer to
Section 5.4.
Setting the Active Channel
1.
Select
Radio
Select Active Channel
.
2.
Enter the channel assignment for this unit. The value must be a
number in the range 01 – 64.
Setting the Receive Frequency
1.
Select
Radio
Receive Frequency for Active Channel
.
2.
Enter the receive frequency for the active radio channel in MHz. The
value must be a number in the format
nnn.nnnn
.
Setting the Transmit Frequency
1.
Select
Radio
Transmit Frequency for Active Channel
.
Summary of Contents for NL6000
