RF Neulink
37
NL6000 User Guide
2.
From the
Main Menu
select
Download New Software
. The
Download
New Software
window opens.
3.
Press
Y
to continue with the software download. If you do not want to
initiate the download at this time, press
ESC
. There is a delay while the
system erases the flash to prepare for the download.
4.
When the system prompts you to send the DSP build, initiate the
download from the terminal emulator.
•
If you use Procomm, use the
Send ASCII Text
option.
•
If you use HyperTerminal, use the
Send Text File
option.
A message appears with the estimated download time. The estimate is
based upon the time it takes using Procomm. If you use
HyperTerminal, the download may take longer.
A countdown message shows the progress of the download. A success
message appears when the download is complete.
5.
When the download is complete, cycle power to reset the modem. This
causes the modem to use the new software build.
6.
Press
ESC
to continue using the
Main Menu
.
Saving Parameters to Disk
If you want to duplicate parameter values on several NL6000 units, you
can save the settings to disk and restore them to multiple units. Use the
following procedure to save parameter values from the unit currently
attached to the serial port.
1.
Select
Save/Restore Parameters
Save Parameters to Disk
.
2.
Using Procomm or HyperTerminal, open the file where you want to
save the parameters.
3.
Press
Y
to confirm that you want to save parameters. If you do not
want to save parameters at this time, press
ESC
.
4.
Wait until the output to the terminal emulator stops. You will see a
checksum at the end.
5.
Stop the text capture function on the terminal emulator and close the
file.
6.
Press
ESC
to continue using the
Save/Restore Parameters
menu.
Restoring Parameters from Disk
If you want to duplicate parameter values on several NL6000 units, you
can save the settings to disk and restore them to multiple units. Use the
Summary of Contents for NL6000
