ESPRIT L Remote control System
Receiver Guide
RELAY 1
RELAY 2
RELAY 3
RELAY 4
FUSE
POWER
TIMER
Timer Select Button
–
Used to select timer mode
Erase Button
–
Press and hold to erase all pairings, see
advanced operation for individual erase
Signal Test mode
–
press to enter signal test mode
Sync/Pair Button
–
Press once to auto pair. See
Advanced operation for other pairing options.
Momentary/Latching Jumper Links
–
It is possible to set the
relay switches on the ELITE receiver to either momentary or latching
operation.
Latching (link removed)
- One press for on, one press for off.
Momentary (link fitted)
- On while button is held only.
To set a relay switch to either momentary/latching choose the
associated link cap.
NOTE: If link is changed, power cycle the
receiver (turn off/on) otherwise it will stay in the same mode it was
previously set in.
110Vac power
input
Power input fuse
–
should be 500mA
Relay switch terminals:
C
om
m
on
N
or
m
all
y
O
p
en
N
or
m
all
y
C
lo
se
d
RELAY 1
RELAY 2
RELAY 3
RELAY 4
SYNC
TEST
ERASE
Status LEDs
–
Flash when
signals are sent/received
L N E
8
7
6
5
4
3
2
1
Mag sync
–
touch a
magnet to the plastic
case in the cross
hatched area to enter
sync mode without
opening the box.
0V
d
c
12
-3
2V
d
c
NO COM NC
NO COM NC
NO COM NC
NO COM NC
CONNECT EITHER
110Vac OR 12-32Vdc
NEVER BOTH
ESPRIT L Remote control System
Pairing a transmitter
NOTE: The transmitter supplied with the system should already be paired.
If an additional transmitter needs to be paired, simply follow the below instructions.
1.
To SYNC a specific ESPRIT handheld transmitter
button to a specific output on the ESPRIT re-
ceiver box—press and release the SYNC button on
the ESPRIT receiver board.
2.
The ESPRIT receiver will flash all its relay output LED
’
s at a high rate to show that it is ready to
SYNC.
3.
Press and release the SYNC button again—the ESPRIT receiver will flash output LED1 this is
showing that output 1 is selected. Pressing and releasing the SYNC button again will select
output 2 and so on, through to output 4.
4.
Once you have selected the required output (only that out-
put LED is flashing) press and release the SPECIFIC button
on the transmitter that you wish to SYNC to the receiver.
5.
The flashing LED
’
s will go out, the SYNC LED will flash quick-
ly for 2 seconds then go out.
