HORNET PRO
DS-HORNETPRO-4
With this system, you can pair together any individual transmitter switch with
any receiver relay switch. Without opening either enclosure:
1.
Briefly (less than 1 second) place a magnet next to the receiver in the posi-
tion shown and then remove it.
2.
The receiver will buzz once (One buzz means the receiver unit is ready to
allocate a transmitter button to relay output 1)To select relay output 2, 3
o 4, briefly place the magnet again so that the Buzzer Buzzes to indicate
the Relay output 2,3, or 4.
3.
Press the switch on the transmitter which you wish to pair
4.
The receiver will buzz twice to confirm pairing
5.
Repeat for any additional transmitter switches
Advanced operation - Pairing a transmitter button with a magnet
Pairing a transmitter button using the LEARN switch option
(12-30Vac-dc Receiver only)
To pair a new transmitter switch follow this procedure:
Unscrew the antenna, Open the enclosure, and extract the Circuit-board assembly
1.
Briefly press the receiver LEARN switch once
2.
The Learn LED will flash once (One flash means the receiver unit is ready to allocate
a transmitter to relay output 1)
3.
To select relay output 2, 3 or 4, briefly press the LEARN switch again and repeat
until the LED flashes 2, 3 or 4 times. The LED will flash the correct number of times
to indicate which Relay output is selected.
4.
Press the button on the transmitter you want to learn to the chosen relay.
5.
The Learn LED will flash to indicate Pairing is complete.
Maximum Number of Transmitters to a Receiver
Each receiver has a maximum memory for up to 30 pairings, these can be from
the same or any number of transmitters.
Erasing Receivers Memory
1.
Press and hold the receiver Learn Switch for ~5 seconds.
2.
The receiver will sound a long Beep to confirm erased.
NOTE: You cannot erase individual Tx encoders
LEARN Switch
