MAINSSWITCH remote control systems
Opens the case by
unscrewing the screws
on the front panel.
On the reverse of the lid
you can find the PCB with
screw terminal
connections
NOTE: Installation to be
By a competent person.
Remove your chosen knockouts from
the enclosure rear section and screw
in the cable glands provided.
remove sealing covers
and screw enclosures to
the wall as required.
Pull cables through
glands insert in crew
terminal connections
and replace front
section.
Wire the Receiver as required -
standard wiring shown.
NOTE: The Relay Switches are rated at:
1.2kW or 6A @ 230Vac
MAINSSWITCH remote control systems
NOTE: Installation to be
By a competent person.
Pairing a Receiver
To pair the MAINSLINK
–
RX it must
have a 230Vac supply connected.
2. When the receiver is in learn mode you will need to pair the transmitter within 10
seconds. To do this you must press the on then off button on the transmitter. (for
non latching transmitters without ON/OFF buttons just press and release the
button you wish to pair)
3. Allow 15 seconds for the receiver to return to normal operation.
Erasing a Receiver
To erase all transmitters from the receiver hold a
magnet beside the learn switch for 10 seconds
as shown.
NOTE: You cannot erase individual transmitter fobs.
1. Briefly place a magnet on the receiver by the
MAINSLINK-RX as shown.
This will put the system in learn mode.
Advanced operation:
Note: All systems are supplied ready paired and would not
require pairing. Pairing is only required for extra transmitters.
