11
Installation
3. Set aside the screws that are affixed to one of the cross slats,
then unscrew the 4 cross slats of the mounting frame and fold
the 8 plates in the frame.
4. Rotate the four fastening plates on the damper 90° (to the
upright position).
5. Open and position the shutter in the mounting frame. If VM
magnet: remove the key from the lock to open the shutter.
Fasten the shutter onto the mounting frame with the 4 screws
supplied with the mounting frame, as shown in the drawing.
Tightening the screws pulls the shutter towards the wall until
its final position.
It also makes it possible to slightly correct the angle of the
shutter with respect to the mounting frame.
Connect the mechanism according to the wiring diagram.
Check the mobility of the shutter.
3
4
5
