1. Purpose of use
RFT-856HD is designed for a processing two DVB-T2/-T mux programs into two DVB-C mux.
2. Installation
The connections and indications are shown in Fig 1.
1. Control switch to program channel 1 (left) or channel
2 (right). The switch must be set to middle position when
programming is ready
2. Channel number ( CCIR)
3. Cable-TV S channel indicator led
4. The signal led shows the output channel mode or that
the unit is powered
5. Signal led indicates that receiver is locked to selected
transport stream
6. ANT IN
7. USB ports are for possible software update
8. RF OUT + DC IN in RFT-800 frame installation
9. DC IN (only in stand-alone installation)
10. DC OUT for next RFT-856 unit (max. 4 units in
chain in stand-alone installation)
11. VIDEO/AUDIO connectors for monitoring
12. IR detector
13. CAM slot , not in this model RFT-856HD
14.
Bit rate indicator. Red = overload, Green = under maximum
RFT-856 can be mounted either to RFT-800 system (RFT-800 User Manual) or stand-alone. Do not
cover the air passage holes.
Signals from antenna are fed to IEC-connectors at the top of unit.
When RFT-856 is mounted for RFT-800 frame, the power voltage is supplied through active output
combiner (RFC-808 or RFC-816). When RFT-856 is mounted stand-alone, power supply unit (RFP-804
or RFP-808) must be mounted to the left side of RFT-856 due to the ventilation. DC connector
is
connected to left side of DC connector at the bottom of unit (9). You can loop-through DC from the
right side DC connector (10) to next unit with the DC cable. Maximum four RFT-856 units in chain can
be supplied with one power supply (RFP-804) in stand-alone installation (max. two units with RFP-
802).
When RFT-856 is mounted for RFT-800 system, cable to network is connected to active output
combiner (RFC-808 or RFC-816). When RFT-856 is mounted stand-alone, RF OUT (8) is connected to
cable network via external RF combiner (RFZ-802).
VIDEO/AUDIO connectors (11) are for monitoring the unit while programming.
NOTE! CA module (13) for smart card must be installed and removed only when power is OFF.
RF-Tuote Oy, Joensuunkatu 13, 24100 Salo tel. +358-2736 6360, fax. +358-2-736 6355, info@rf-tuote.fi, www.rf-tuote.fi
