AS
Mxxxx Series User’s Manual
Asia Pacific | EMEA | Americas
23
This is done for example in Windows 7
™ in the following manner;
1. Select “Start” from status menu
2. Single click
– “Control Panel”
3. Single click
– “ Network and Sharing Center”
4. Single click -
“Change Adapter Settings” on the left hand side menu
5. Single Click
– “Local Area Connection” box
6. Single Click
– “Change Settings of this Connection”
6. When the Local Area Connection Properties box opens, select only
the “Internet Protocol 4 (TCP/IPv4)” choice.
7. Click “Properties” button.
8. Click “Use the following IP address”.
9. Enter next to
IP address
192.168.1.180
10. Enter next to
Subnet mask
255.255.255.0
11. Enter next to
Default gateway
192.168.1.254
12. Click “OK” to initiate changes.
Should you still be unable to successfully connect to the ASM via the default IP address then the IP address may have already
been changed. If there is no possibility of recovering the changed IP address, then it will be necessary to reset the ASM to the
factory default settings.
Reset Factory Default Ethernet Addresses and Access.
To reset the ASM back to the Factory Default settings will mean a complete reset of all RF configuration settings and alarm
threshold parameters as well as the IP address parameters. To do this, simply switch the ASM off by removing the DC power
cable connector. Press the factory reset button on the rear of the ASM, reconnect the DC power while continuing to hold the
reset button down until the green power LED light flashes, the Factory reset has started and the reset button may be released.
Wait for the ASM to complete its default re-configuration and to restart.
NOTE:
This will cause the IP address, subnet and gateway addresses and all other configuration data
to be reset back to factory default address.
Factory Default settings
DHCP
- Disabled
IP Address
- 192.168.1.200
Subnet Mask
- 255.255.255.0
Gateway
- 192.168.1.254
Level 1 User Name:
user
Level 1 Password:
user
Level 2 User Name:
admin
Level 2 Password
: admin
Level 3 User Name:
master
Level 3 Password
: master
Reset RF Default settings.
To reset the ASM back to the RF Default settings will mean a complete reset of all RF configuration settings and alarm threshold
parameters. The above Factory Default Ethernet and Access settings will remain unchanged.
Should you wish to only reset the RF configuration settings, simply press the factory reset button (without disrupting power) until
the green power LED light flashes, the RF reset has started and the reset button may be released.
