RFL Network Management Software
4.2
SOFTWARE INSTALLATION
This section describes how the NMS and PLC software is installed into your PC. The following
procedure can also be used to install updated NMS or PLC programs into your PC as they are released.
Before attempting to install the software into your PC, there are some important facts that must be
considered:
1.
The software is shipped from the factory on one CD, labeled “SW9508DNMSxxx”,
where xxx can be 001 to 999.
2.
Before loading the software make a working copy of the CD. Store the original CD in a
safe place, and use the working copy to load the software into the PC.
3.
Before installing the software, it is recommended that you run CHKDSK or
SCANDISK to verify that no problems exist on your hard disk, and to verify available
disk space. You will need about 40 megabytes free for a complete installation.
4.
As you are installing the software, several lists of choices will appear on the screen;
read the instructions below each list carefully before making your choice.
5.
If this is a new installation, proceed as described in paragraph 4.2.1.
CAUTION
RFL 9508D UCC
RFL Electronics Inc.
If you are upgrading to a new RFL NMS version, un-install the old RFL NMS version as
described in paragraph 4.2.2, install the new RFL NMS version as described in paragraph 4.2.1.
September 7, 2012
4-2
(973) 334-3100
