RFL Network Management Software
2. Read Teleprotection
This button is used to read the parameters from the digital channel tab and common tab from the
Teleprotection transceiver.
3. Show Maps
Through this button you can see the value of the register to be written to the transceiver and/or read
from it. This option can also be found in the menu:
transceiver/show memory maps
and
teleprotection/show memory maps
.
Note: This button is only available when logged as an administrator.
4. Address Discovery
Pressing this button the software will start an address scan from 0 to 127, to find the address of the
Analog XCVR transceiver and teleprotection transceiver. After discovering the addresses, the
corresponding values on the window shown through the menu
file/program settings
will be updated.
The second page inside the teleprotection window is the ‘admin setup’ which is shown below.
Note: this page is visible only when logged in an administrator session.
Figure 4-15. Analog XCVR channel administrator settings window
The parameters configured in this window are:
RFL 9508D UCC
RFL Electronics Inc.
September 7, 2012
4-19
(973) 334-3100
