Check if code of transmitter is stored in the receiver according chapter “Check if learning succeeded”/“3)
Learn tansmitter” of “C. Before Use” above. If sure then go to next step. If not, have receiver learn
transmitter according “3) Learn tansmitter” of “C. Before Use”.
2) Test
To check if continuity is with the connection of e-match or iginter and output terminals.
When an e-match or igniter is connected, shift Rocker Switch #15 at Test, if Cue Test LED is on and Cue Fire
LED is off, it indicates continuity is with the cue; otherwise the connection is interrupted.
3) Fire
When connection is tested with continuity, shift Rocker Switch #15 at Fire, press button of the transmitter
to send signal, Cue Fire LED will blink, firing current will be sent out. See chapter “B. How system works
in Two Firing Modes” above.
Manufacturer: RFRemotech
E-mail:
September, 2010
Page 6 of 6
