NMT 552-01e
7/8
9.
Elevation fine adjustment
(Feed system not shown)
10.
Azimuth fine adjustment
(Feed system not shown)
Loosen M10 nuts of
the 2 V-Bolts
Torque tighten the 2 M10
screws
(refer to torque table
joined)
, then loosen it, ¼ turn
Loosen or tighten M10
brass nuts to adjust
the Elevation
After complete elevation
fine adjustment, torque
tighten the 2 M10
screws
After complete Azimuth fine adjustment, lock each first nut of the V-bolts
(greased)
at the
specific torque, (refer to torque table joined) then tighten the second nut against the first
one using usual wrench (do not use 2 wrenches to fix the second nut). Then tighten the 2
brass nuts M10 of the Azimuth spindle.
Principle for
an installation
with a left offset
Principle for
an installation
with a left offset
Loosen or tighten
M10 brass nuts to
adjust the Azimuth.
