Cordless Jack Nurse-call
Quick Start Guide
1.
Follow the steps below to set up your equipment:
Pull out the battery tab to power up the Wireless Jack
or insert 3 AAA batteries. Green and yellow lights will illu-
minate to confirm batteries have been inserted correctly.
2.
Confirm the mono/stereo switch and the on/off switches
are in the correct position.
MONO/STEREO
-
refer to your nurse-call system configuration
ON/OFF
-
only turn ON when a nurse-call button is inserted to
the call cord socket.
3.
Plug the wireless jack into the socket on your nurse-call
panel.
4.
5.
Ensure that the sensor pad is placed on a smooth flat
surface and the pad is not creased or folded in any way.
Check that you have positioned your sensor pad
correctly and switch the transmitter on (inside pouch).
To test, activate the sensor to confirm that it is alarming
and resetting correctly.
Ramblegard Technical Support Helpline:
028 9448 3979
When you are satisfied with the points above please complete the
daily checks sheet provided before putting the system into use.
6.
When you first switch on the pad transmitter, apply
pressure to the sensor pad for at least 15 secs to wake
up the transmitter from sleep mode. Failure to do this
will cause the Companion to loose connection from the
transmitter and trigger an audible alert. This only applies
when you switch a transmitter from OFF to ON.
