4
DTR_319-01-01-001_EN_b
3.2
TL-70-2 dimensions
Fig. 2
3.3
Mounting the light signalling device
3.3.1
Mounting bracket
The roof functions as a mounting bracket (Fig. 3).
Fig. 3
4.
Device installation
Correct installation consists in mounting the device in a standard way, namely, on a flat surface or using one of
the alternative methods allowed by the manufacturer. In both cases, the device must be mounted with the
wires facing down. Only the correct installation of the device ensures its proper operation and the maintenance
of the device parameters, like, among others, the housing tightness rating satisfying the required IP code.
NOTICE!
Before any installation or maintenance operations refer to the manual supplied by the manufacturer. Improper
connection to the mains power supply, incautious device installation, or improper use may cause the property
damage, loss of health or death from electric shock! In addition, failure to comply with the manufacturer's
instructions may void the warranty.
NOTICE!
It is forbidden to make any additional mounting points or any holes in the device assembly components.
