8
DTR_314-01-01-001_EN_d
6.
Automatic brightness control of the display for weighing scales
6.1
Lighting sensor
In the standard version, the display for weighing scales has a lighting sensor included, which is placed on the LED
panel. The device, in response to the intensity of daylight, adjusts the brightness of the display for weighing scales.
7.
Initial start-up
Step 1: Make sure that all cables are properly connected,
Step 2: Make sure that all components have been installed in the correct orientation
(wires down)
,
Step 3: Connect the device to the mains power source,
Step 4: If properly connected, the system will display moving arrows (<<<<), followed by the symbol of a hard
space (_) shown in the bottom right corner, which means that the user has 7 seconds to send the
configuration to the display for weighing scales. If the user does not enter the configuration, the display
will start the Autolearn procedure. If the process is successful the "Ready" text is shown and then the
unit is ready to show weighting results.
8.
Disposal and recycling
8.1
Recycling of packing materials
The packaging materials must be segregated , then recycled in accordance with local regulations for
waste disposal regulations.
8.2
Disposal of the device
The device can not be disposed with regular household waste!
According to Directive 2002 / 96 / EC ( WEEE ) , when repair is not economically reasonable, user is
obligated to hand over damaged or destroyed device to an appropriate disposal facility .
9.
Most common errors during the installation
1
Incorrect configuration uploaded to the display for weighing scales.
2
Drilling additional mounting holes.
Because the product is constantly developed, presented data is subject to change without notice.
