No Output in Large Screen
1. Check whether input the signal.
2. Check whether the interfaces are in good connection.
3. Check if the input wire and output wire are normal.
Common Questions and Solution
Display shows no bottom half part
Sending card does not support the bottom half
part:
There are limits for different sending cards. As
for Linsn TS802, if output resolution is 1920 or
higher, while every LAN port can support only 320
height LED screen, more than this value need to add D
mouth reticle, more than 640, need to add more
sending cards as cascade.
LED display shakes
Sending card input recognition is not correct:
It
usually occurs when use sending card improperly or
hot plug. It is normal before, but LED display shakes
after change the output resolution. Generally, it will
normally operate if reboot the device.
Address: S603-604 Weiye Building Torch Hi-Tech Industrial Development Zone, Xiamen, Fujian Province, P.R.C
Tel: 00865925771197 Fax:00865925771202
Email: rgblinkcs@gmail.com http://www.rgblink.cn
DV4 Quick Start
Rev 1.0
Page 2 of 2
