5
Figure 2-4.
Mounting the Canopy Braces
CAUTION:
CANOPY FRAME MUST BE SQUARE TO PREVENT DAMAGE AND/OR IMPROPER
FITTING OF CANOPY FABRIC UPON INSTALLATION.
5.
Refer to
Figure 2-5.
Attach each canopy end cap to the side stringers using hardware shown for each corner
connection. Before tightening hardware, square the canopy frame by placing a carpenter or combination square into
each corner and positioning canopy stringers and end caps to provide a 90 degree corner joint. Tighten hardware to
lock into position.
6.
Verify canopy frame is square by measuring the diagonal distance from the outside of canopy frame corner to opposite
corner. Repeat for alternate corners. The
difference between the two measurements shall not exceed 1/4 of an inch
.
Repeat steps 5 and 6 if necessary.
Canopy Frame Diagonal Measurement Diagram
(Measure to Outside Corners)
