Manual CE (SAGOMA _GB)
XX.X
This parameter visualises the value of the supply tension at the 24 V actuators. This value should
be included between 24 V and 28 V.
At the end of programming, press
button 1
to confirm the set data.
12.5.7 Reading of the sales data
The last sub-menu which can be selected in the programming mode concerns the reading of the
sales data. The machine keeps various counters stored, which allow a direct reading for
consumption and cashing.
To have an immediate reading of the total number of cycles carried out, simply keep pressed the
key
FREE
the machine with the machine switched on and with the invitation message visualised.
The following message will be displayed:
T CYCLES
XXXXXX
All counters, except that of total cycles, can be set to zero. To reset a counter, when it is visualised
on the display, press
button 4
.
Read the parameter, in the programming mode, by pressing
button 1
until the sub-menu
SALES DATA - - - - - -
- - - - - - - - - - - - - - - - -
is displayed.
Then press
button 2
and the following counters are shown in sequence:
T CYCLES
XXXXXX
This value indicates the total sale cycles of the machine. This is the same value, which is shown
when the a.m.
key
FREE
is pressed. This value cannot be set to zero.
P CYCLES
XXXXXX
This value indicates the partial number of sale cycles of the machine starting from the last reset
operation.
P CASHING
XXXXXXXX
This value indicates the amount of money cashed starting from the last reset operation.
TESTS
XXXXXX
42/42