Operative Instructions
30
a
WARNING! It is mandatory to record the
annually water inlet filters cleaning in the
Maintenance Logbook.
9.5.2 Cleaning of small rotating nozzle
1) Unscrew the fixing screw of the head of nozzle.
2) Dismount the rotating head.
3) Remove the nozzle’s pin.
4) Clean them with water of compressed air.
5) Reinstall all.
a
WARNING! It is mandatory to record the
annually rotating nozzle cleaning in the
Maintenance Logbook.
9.5.3 Replacing of door gasket
1) Remove the old gasket.
2) Insert the upper angles of gasket.
3) Press inside all the upper part of gasket.
4) Insert the lower ends inside the slots.
5) Help the sliding of the gasket with some oil.
6) Slides the gasket up the end of the slot.
7) Press inside the sides of the gaskets.
a
WARNING! It is mandatory to replace the
door gasket as indicated in the Maintenance
Logbook. In case of intensive use of the
machine it is recommended to increase the
frequency of maintenance.
9.5.4 Cleaning of level probe in storage tank
1) Power off the machine.
2) Remove the upper panel of the device, using the
provided key.
3) Disconnect the connector from the probes
4) Extract the probes from the water tank.
5) Clean the steel rods, possibly using softener liquid
and being careful not to scratch them.
6) Reinsert the probes in their housing;
7) Restore the power to the device.
a
WARNING! It is mandatory to record
the annually level probe cleaning in the
Maintenance Logbook.
9.5.5 Replacing the air suction filter
The machine is equipped with an «absolute» «HEPA
H14» air filter, in compliance with EN 1822.
1
2
Fig. 17
If the filter is dirty, replace it by following the
instrunctions below:
1) Remove the cover panel (4 Fig. 2.1 and Fig. 2.2).
2) Remove the filter by lifting one of the two hooks (1
or 2 Fig. 17).
3) Place the new filter, taking care to position the black
gasket on the machine side (fig. 18).
Fig. 18
4) Replace the cover panel.
a
WARNING! It is mandatory to replace
the HEPA H14 filter as indicated in the
Maintenance Logbook. In case of intensive
use of the machine it is recommended to
increase the frequency of maintenance.
Summary of Contents for DVS
Page 40: ...Operative Instructions 40 Notes ...
Page 41: ...Operative Instructions 41 Notes ...
