6
BATTERY INSTALLATION
1.
9 volt Battery required (not included).
Use a new battery with “use date” at
least 4 years in the future. Pre-used or
old batteries will likely cause your lock
to malfunction.
2.
Place palm under keypad and push UP.
3.
Gently pull keypad away from safe.
Install battery, taking care not to pull
out wiring harness.
This applies to SecuRam and LaGard electronic locks only.
Getting Started—Electric Lock
OPENING YOUR SAFE FOR THE FIRST TIME
1.
After installing battery, enter factory default
combination of 1-2-3-4-5-6 to activate your
lock.
2.
Test the operation of the lock several times
with the door open before attempting to
change the code. Instructions for changing
the code are on page 8.
