Attention
When removing shipping feet, start on one side and then move to the
other. Only remove one shipping foot at a time.
If your safe is under 500 lbs, use a minimum of 2 people. If your safe is
over 500 lbs, professional installation is highly recommended.
1. Make sure door is closed and handle is
spun counter-clockwise to keep safe
door closed.
2. On a Bighorn or Kodiak, you will need
either a 17mm or a 19mm socket
wrench to remove the shipping feet.
(
Wrench not included
)
3. Place wrench on head of bolt. Begin
turning bolt counter-clockwise to re-
move. Repeat for both bolts.
4. Angle the safe to the left (or right for
left side shipping foot) slightly, as
shown, and carefully pull shipping feet
away from bottom of safe.
5. Once the shipping foot has been re-
moved from one side of the safe, care-
fully lower safe to the floor.
Proceed removing bolts from other side
of the safe, and follow steps 4 and 5.
Have an assistant brace the safe.
Use a minimum of two people for this
step.
3
Removing Shipping Feet
On Your Bighorn or Kodiak Safe