TPI
TPI
To add a new transmitter to your alarm, simply follow the procedure below.
1.
Sit in your vehicle with all doors closed. Turn the ignition to on to disarm the immobilizer, then switch ignition to off.
2.
Now open & close your drivers door.
3.
Now turn the ignition from off to on
20 times
within 30 seconds (finishing in the off position). The LED will flash a few
times to confirm that you have entered the learning mode. Remove your keys from the ignition keyswitch, taking the
transponder attached to your keys out of reading range, i.e. more than15cm.
4.
Wait for the LED to stop flashing, then bring the first transponder you wish to use into range of the inductive
coil, i.e. within 10cm of your ignition keyswitch. The LED will flash once to confirm that this transponder code has been
learnt that you wish to add.
Once again the LED will flash to confirm that this transponder has also been learnt.
Up to 4 transponders can be programmed into your TPI.
5.
10 seconds after the last transponder has been presented, the system will automatically exit and return to armed mode.
CK+CLK
Car King
ALDI
GLTX
Red
LED
(Up to 5 remote controls can be used with this alarm system)
Note that this system can learn the same remote in more than once. Only one remote can be learnt in on each
learning mode session.
Disconnect all power to the system and then reconnect the power. The system is now in learn mode and will
remain so for ten seconds.
To learn a remote in, immediately press the button on the remote and the alarm will disarm. This is indicated by
two beeps from the siren.
Once a remote control has been learnt in the device is no longer in learn mode. To learn another remote in
simply repeat the procedure.
Erasing Lost Remote Controls:
If you lose a remote control or perhaps have your car keys stolen, you can simply
erase the lost/stolen remotes by repeating the procedure above 6 times. This will fill the system memory with
remotes that only you have in your possession.
