2
♦
Wireless Detectors available include PIR's, Internal or External Reed Switches, Smoke Sensors & Wireless Emergency
Pendants.
+12VDC
Ground
Zone 1 Detector Output
Zone 2 Detector Output
Zone 3 Detector Output
Zone 4 Detector Output
Supervision Output
Low Battery Output
Panic Output
On/Off Output
Keep the antenna vertical &
straight and away from
metal. Mount the receiver
inside the top of your panel
box with the maximum
possible length of antenna
extruding from the top.
ARM/DISARM: Press the button once. As soon as you
release, the alarm will respond.
PANIC: Activate by pressing & holding down the button for
3 seconds. This sets off the siren. To cancel “panic”, press
the button once.
Red
Red
Yellow
Green
Receive
Valid
Program
Run
LED'S
1 2 3 4 5 6 7 8
ON
OFF
Antenna
Wire
Add
User Code
Bank 1
Receive: On when any data packets are received - even if codes are
not programmed.
Valid: On while valid data is decoded e.g. while Tx is pressed or PIR
transmitting. Flashes 6 times when in program mode and valid data is
received for storage.
Program: On when any switch is in the “on” position, flashes when
more than one switch is in the on position.
Run: Normally flashing at 0.5 Hz - indicates microprocessor is
running
Delete