5
After connecting your
KISS-RX
to your panel as per the connection diagram on page 2,
carry out the default procedure outlined below.
You can default your
KISS-RX
in case you make a mistake, or are unsure of your receiver setup.
"Defaulting" your receiver will cause all detector & remote codes to be erased.
To default your receiver, follow these steps:
1.
Set all dipswitches on Bank 1 to ON.
2.
Press & Hold the delete button for 1 second.
3.
All LED's on the receiver will flash once together to confirm that the receiver has been defaulted.
4.
Return all dip switches back to the OFF position.
IF YOU ENCOUNTER ANY PROBLEMS WITH
YOUR KISS RX OR REQUIRE ADDITIONAL
TECHNICAL INFORMATION NOT CONTAINED
IN THIS MANUAL
PLEASE CONTACT YOUR RHINO DEALER
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
1 2 3 4 5 6 7 8
Bank 1
ON
OFF
%
Delete
1 second press