Driving a Post
1.) Start with the unit on the ground running
and with the opposite end of the post lined up
with where it will be driven into the ground.
2.) Raise the chuck tube and insert the post
fully into the chuck tube. Raise the driver and
post together.
3.) Holding the post driver with your left hand
on the foam grip and your right hand on the
throttle will position the driver to direct the
engine exhaust away from the operator.
4.) Position the driver aligned centered
to the post. Do not allow the driver to tilt
forward, back or to the side. If not aligned
properly, damage could be caused to the
driver or the post.
5.) Apply steady downward pressure to
the handles and apply enough throttle to
engage the clutch and hammer.
6.) Once you are confi dent that the post
is driving straight, apply full throttle to
the driver until the post is driven to the
desired depth.
7.) Release the trigger dropping the
engine RPM back to idle before
removing from the post. When the
engine has returned to idle, proceed
to the next post repeating the previ-
ous method of driving a post.
When driving tall post, follow safe
working practices by having a second
person as a helper and work from a
safe elevated height. Do not attempt
to drive a tall post if the operator is
not in the proper position to operate
the post driver safely.
Storage
Improper storage can reduce post
driving effi
ciency and cause the
engine to run sluggish. When storing
your Multi-Pro XA,
DO NOT
lay
it horizontally on the driver side
or resting on the engine. If the unit
cannot be stored securely in an
upright position, place the chuck
with locking nut installed on the fl at
surface, lean it toward the engine side
until it is supported by the shroud and
chuck. This will position the driver
on an angle with the top handle at the
topmost point.
Post
Driver
Post
RIGHT
WRONG
QuickSTART
OPERATING INSTRUCTIONS
RHINO
®
Multi-Pro XA
™
Gas Powered Driver
To see Rhino
®
Gas Powered Drivers in action visit our
YouTube Channel at: https://www.youtube.com/chan-
nel/UCgL37X-G6zaHQ-sCmfB_oNg/feed
Lean from chuck till supported by chuck and shroud.
Suspended or secured vertically upright.
WRONG
RIGHT
QR FOR RHINO TV
QR FOR RHINO DEALER LOCATOR
Form No.: 000324-5/2016
© 2016 Rhino Tool Company Inc., - All Rights Reserved
Proper Storage Methods
Visit www.rhinotool.com to
locate a dealer near you.
Proper operator position
Driving position on a post.
Rhino Tool Company, Inc.
309-853-5555 or 866-7071808
info@rhinotool.com
www.rhinotool.com
