background image

18 

WARRANTY TERMS & CONDITIONS 

 
RhinoCo Technology (The Company) warrants its products to be in 
conformance with its own plans and specifications and to be free from defects 
in materials and workmanship under normal use and service for 12 months 
from the date stamp control on the product, or for products not having a date 
stamp, for twelve months from the date of original purchase unless the 
installation instructions or catalogue sets forth a shorter period, in which case 
the shorter period shall apply. The Company’s obligation shall be limited to 
repairing or replacing, at its option, free of charge for materials or labor, any 
part which is proved not in compliance with The Company’s specifications or 
proves defective in materials or workmanship under normal use and service. 
The Company shall have no obligation under this Limited Warranty or 
otherwise if the product is altered or improperly repaired or serviced by 
anyone other than The Company.  
 
For warranty service, return transportation prepaid, to RhinoCo Technology, 9 
Hannabus Place McGraths Hill  NSW 2756 Australia. 
 
There are no warranties, expressed or implied, of merchant ability, or fitness 
for a particular purpose or otherwise, which extend beyond the description on 
the face hereof. In no case shall The Company be liable to anyone for any 
consequential or incidental damages for breach of this or any other warranty, 
express or implied, or upon any other basis of liability whatsoever, even the 
loss or damage is caused by its own negligence or fault. 
The Company does not represent that the products it sells may not be 
compromised or circumvented; that the products will prevent any personal 
injury or property loss by burglary, robbery, fire or otherwise; or that the 
products will in all cases provide adequate warning or protection. Customer 
understands that a properly installed and maintained alarm system may only 
reduce the risk of a burglary, robbery, or fire without warning, but it is not 
insurance or a guarantee that such will not occur or that there will be no 
personal injury or property loss as a result. 
Consequently, The Company shall have no liability for any personal injury; 
property damage or other loss based on a claim the product failed to give any 
warning. However, if The Company is held liable, whether directly or 
indirectly, for any loss or damage arising under this limited warranty or 
otherwise, regard less of cause or origin, The Company's maximum liability 
shall not in any case exceed the purchase price of the product, which shall be 
the complete and exclusive remedy against The Company. 
 
This warranty replaces any previous warranties and is the only warranty made 
by the Company on this product. No increase or alteration, written or verbal, 
of the obligations of this Limited Warranty is authorised.

  

 

 

 

 

 

 

 

Summary of Contents for Trans TX









Reviews: