47
(4) Start circuit is disabled.
(5) Electromagnetic relay armature is adherent;
(6) Starter fault
(7) Driving gear of starter is stuck by engine flywheel gear ring;
(8) Driving gear of starter adheres to the bearing.
(9) The starter fails to drive the engine;
(10) Engine fault;
How to solve:
(1) Check if the battery is fully charged; if not, charge it; change the battery if necessary.
(2) Connect the battery terminal and connector;
(3) Repair the battery earth wire.
(4) Inspect the start circuit and ensure the terminal of starter shall be live.
(5) Inspect starter electromagnetic relay to eliminate fault of electromagnetic relay; it shall obvious to hear the
sound making by the relay when it sucks and separates.
(6) Inspect and repair the starter.
(7) Start again to engage the starter driving gear and engine flywheel gear.
(8) Inspect the bearing on the end of starting shaft of starter;
(9) Small torque of starter, change the starter if necessary.
(10) Repair the engine to ensure sound operation of engine.
Summary of Contents for XN08
