Page 5
2. Install the new front seat back support brackets where the original brackets were
installed. Mount the front most portion using the Original Hardware (black arrows).
3. Place the horizontal supports under the seat back brackets as shown. Fasten them
to the vertical support brackets using (2) M10 x 30 Hex Head Bolts (4) Flat Washers
and (2) Nylock Nuts (blue arrows, Bag #2).
4. Fasten the horizontal supports and the front seat supports to the rear body
using (2) 5/16”-18 x 1.5” Hex Head Bolts, (2) Fender Washers and (2) Original Nuts
removed earlier (red arrows, Bag #1).
5. Reinstall the access panel using the Original Hardware.
6. Loosely fasten the footplate to the vertical support brackets using (2) M10 x 30 Hex
Head Bolts, (4) Flat Washers and (2) Nylock Nuts (Bag #2).
