Rhyas EFM4001, Manual

(en)

   We declare under our sole responsibility that this product is in conformity with directive 2011/65/EU 

of the European parliament and of the council of 9 June on the restriction of the use of certain 

hazardous substances in electrical and electronic equipment is in conformity and accordance with the 

following standards and regulations:

EN

11

en 55014-1, en 55014-2, en 60745-1, en 60745-2-4,

en 61000-3-2, en 61000-3-3

2006/42/eC, 2006/95/eC, 2004/108/eC, 2002/96/eC, 2011/65/eU

Zwolle, 

01-05-2014     

W. Dekens

CEO Mactool Industrial BV

It is our policy to continuously improve our products and we therefore reserve the right to change the product specification 
without prior notice. 

Mactool Industrial BV • Lingenstraat 6 • 8028 PM • Zwolle The Netherlands

DeClaratIOn Of COnfOrMIty

efM4001

h.   Damaged switches must be replaced at a cus   to mer 

service repair centre. Do not use power tools that 
cannot be switched on and off.

i.   Do not leave power tools unattended while they are 

switched on. Always switch off the tool and wait until it 
has come to a full standstill before leaving.

j.   If the mains cable has been damaged, it must be 

replaced with a special mains cable. These can be 
obtained from the manufacturer or the manufacturer’s 
custo mer service department. The mains cable 
may only be replaced by the manufacturer, the 
manufacturer’s customer service department or equally 
qualified persons.

5)  Battery tool use and care

a.   Ensure the switch is in the off position before inserting 

battery pack. Inserting the battery pack into power tools 
that have the switch on invites accidents.

b.    Recharge only with the charger specified by the 

manufacturer. A charger that is suitable for one type of 
battery pack may create a risk of fire when used with 
another battery pack.

c.   Use power tools only with specifically desig nated 

battery packs. Use of any other battery packs may 
create a risk of injury and fire.

d.   When battery pack is not in use, keep it away from other 

metal objects like paper clips, coins, keys, nails, screws, 
or other small metal objects that can make a connection 
from one terminal to another. Shorting the battery 
terminals together may cause burns of a fire.

e.   Under abusive conditions, liquid may be ejected from 

the battery; avoid contact. If contact accidentally occurs, 
flush with water. If liquid contacts eyes, additionally 
seek medical help. Liquid ejected from the battery may 
cause irritations or burns.

6) Service

a.   Please use a qualified expert who uses original 

replacement parts to repair your power tool. This will 
ensure proper functioning of the power tool.

b.   Caution! The use of any accessories or additional tools 

other than those recommended in this manual may 
lead to an increased risk of injury. Only use original 
replacement parts.