OR
2. Add Card: Block Learn
(Allows manager to add up to 2000 cards
to the Reader in a single step.) Takes 3
minutes to program.
1 ( User ID number) # (Card quantity)
#(The first card number) #
Cards’ number must be consecutive;
Card quantity = number of card to be enrolled.
3. Exit
﹡
﹡
﹡
﹡
Delete User Cards
Programming Step
Keystroke Combination
1. Enter Program Mode
﹡
﹡
﹡
﹡
(Master Code) #
2. Delete Card: By read card
OR
2. Delete Card: Select Specific ID
OR
2. Delete Card: by Card Number
2 (Read Card) #
Repeat Step 2 for additional user cards
2 (User ID) #
The user ID is any number from 1-2000.
2 (Input 8/10 digits Card number) #
Set Relay Configuration
The relay configuration sets the behaviour of the output relay on activation.
Programming Step
Keystroke Combination
1. Enter Program Mode
﹡
﹡
﹡
﹡
(Master Code) #
2. Pulse Mode
OR
2. Latch Mode
3 (1-99) #
The relay time is 1-99
seconds(default is 5 seconds)
3 0 #
Sets the relay to ON/OFF Latch mode
3. Exit
﹡
﹡
﹡
﹡
Set Strike-out Alarm
The strike-our alarm will engage after 10 failed card attempts. Factory is OFF. The strike-our alarm ca
be set to deny access for 30 minutes after engaging or it can be set disengage only after entering a valid
card or Master code.
Programming Step
Keystroke Combination
1. Enter Program Mode
﹡
﹡
﹡
﹡
(Master Code) #
2. Strike-Out OFF
OR
2. Strike-Out ON
OR
2. Strike-Out ON (Alarm)
Set alarm time
4 0 #
(factory default)
4 1 #
Access will be denied for 10 minutes
4 2 #
5 (0 ~ 30) #, factory default is 1 minute
Enter Master code # or valid user card to
silence
3. Exit
﹡
﹡
﹡
﹡
