19
7. Selectable functions through dip-switch
It is important to change the configuration of the dip-switch only when the unit is turned off!!!
Turn off the power supply during the change of configuration.
Default settings
The control board is supplied with the dip-switches set as indicated in the Pict. 1.
In the table are sum up the functions that can be selected through these dip-switches.
Fig.1
7.1 Functioning on opening/closing
This function enables to select the method of opening/closing of the automation.
ON
OFF
ON
OFF
ON
OFF
ON
OFF
The automation operates under dead man mode on opening.
The automation operates under pulse mode on opening.
The automation operates under dead man under on closing.
The pause time for automatic closing, even if it is set, will not be implemented.
The automation operates under pulse mode on closing.
The operating mode with “pulse function” activated can be selected by the dip 4.
dip
Function
Dip OFF
Dip ON
1
Function on opening
Dead man
Impulse on opening
2
Function on closing
Dead man
Impulse on closing
3
Working time
Programmable
Infinite
4
Pulse functioning
Open - Close
Step by step (function GO)
7.2 Working
time
The setting of this dip enables to choose between a working time manually set through a trimmer or an infinite working time.
ON
OFF
ON
OFF
An infinite working time is set, the output remains activated till the reception of a stop or an opposite motion impulse.
The pause time for automatic closing, even if it is set, will not be implemented.
The working time is manually set through the “Run Timer” trimmer adjustment (see paragraph 6).
G
B
