IMPORTANT INSTRUCTIONS FOR THE
SAFETY
G
B
3
3
KEEP THESE INSTRUCTIONS WITH CARE
1° - If it is not forecast in the electric gearcase, install a switch of
magnetothermic type upstream, (omni polar with minimum
port of the contacts of 3 mm) with a check of conformity to the
international standards. Such devise must be protected against
the accidental lockup (for example by installing inside a locked
board).
2° - For the section and the type of the cables, RIB advices to use a
cable of the H05RN-F type with minimum section of 1,5 sqmm
and, in any case, to keep to the IEC 364 standard and to the
installation standards in force in your country.
N.B.: The system must be grounded
Data described by this manual are only Indicative and RIB reserves
to modify them at any time. Install the system complying with current
standards and regulations.
FOLLOW ALL INSTALLATION INSTRUCTIONS
1° -
This handbook is exclusively addressed to the specialized
personnel
who knows the constructive criteria and the protection
devices against the accidents for motorized gates, doors and
main doors (follow the standards and the laws in force).
2° - The wiring harness of the different electric components external
to the operator (for example photoelectric cells, flashlights etc.)
must be carried out according to the EN 60204-1.
3° - The possible assembly of a keyboard for the manual control of
the movement must be done by positioning the keyboard so
that the person operating it does not find himself in a dangerous
position; moreover, the risk of accidental activation of the buttons
must be reduced.
4° - Keep the automatism controls (push-button panel, remote control
etc.) out of the children way. The controls must be placed at a
minimum height of 1,5 m from the ground and outside the range
of the mobile parts.
5° - Before carrying out any installation, regulation or maintenance
operation of the system, take off the voltage by operating on the
special magnetothermic switch connected upstream it.
THE RIB COMPANY DOES NOT ACCEPT ANY RESPONSIBILITY
for possible damages caused by the non observance during the instal-
lation of the safety standards and of the laws in force at present.
- ATTENTION -
FOR THE SAFETY OF THE PEOPLE IT IS IMPORTANT TO
FOLLOW ALL THE INSTRUCTIONS.
