CS-600A Operation Instructions V1.1
Page 10 of 16
·
Press CLR key to clear to Zero;
·
+1000
、
+100
、
+10
、
+1 keys are for value setting:
①
+1000 is 10, +100 is 1, +10 is 0.1, +1 is 0.01;
②
One press increase the digit by 1. e.g. press +1 key once is 0.01,
double press is 0.02;
·
Press
and
to select different channels.
·
After setting, press VAL key to exit and enter total display.
Printer operation and paper assembly(option)
A. Printer operation
After switching on the power, press SEL key on the printer to select the
connection mode
（
RS232
）
with the sorter. In this case, the lamp is on. It means
that the printer is on-line and the data can be received. Normally the printer
should be in this mode, so the printer could print the counting report at any
time. If the lamp is not on, the printer is off-line. It cannot receive the data. In
this case, you can feed the paper by pressing LF key. Subsequently, you can
stop the paper feeding by pressing LF key. During printing, the printer can be
stopped by pressing SEL key.
B. Paper Assembly
Push the cover
，
then take out the printer
and hold tightly the two ends of paper axis,
remove it from the fixed notch, renew the
paper tape roll and return it into the fixed
notch. By pressing SEL key ,switch off the
lamp; lead the print paper to the notch of
feed paper, then feed the paper by
pressing the LF key. Install the cover, press the SEL key, switch on the lamp
and it returns to the ready printing mode.
