Page 33 / 64
Fig.5
Fig.6
4.2.2- For log splitter 8T - PREHLS7T/V / 042091
4.2.2.1- Control lever assembly (Fig.7)
-
Put arm in its position: insert arm’s tube into the bracket.
- Insert long bolt (A)
- Fix bolt (A) on its lower side with the washer and nut.
- Make sure to tighten all screws after control lever
assembly.
Fig.7
4.2.2.2- Adjusting the ram travel (Fig.8 & 9)
Should your logs be much shorter, the machine working capacity can be
increased by to adjusting the ram stroke accordingly. The ram stoke
adjustment is possible at all times.
1. Place a log on the working table and let the ram slide down until the
wedge is about 2cm from the log (Fig.8).
2. Disengage one of the control levers in order to prevent the ram from
returning back to its upper start position.
3. Switch off and unplug machine from its power supply.
4. Release the second control lever handle.
5. (a) Release the knob (A in Fig.9) on the rear
(b) Pull up the control rod (B in Fig.9) as much as possible, until
desired length is set.
(c) Once the rod is pulled sufficiently up to obtain the desired ram
stroke, tight the knob back to the original torque.
The ram travel is now shorter than the original full-stroke.
The ram travel adjustments to the original full-stroke length can be
repeated at all times by simply releasing the knob, pushing the rod back
and tightening the knob again
Fig.8
Fig.9
4.2.2.3- Table height adjustment (Fig.10)
