Page
12
/
24
IV. GETTING STARTED
4.1- Unpacking
•
Remove the product from packaging.
•
Check if the product and accessories (if any) are intact.
4.2- Content
•
1 multimeter
•
1 battery (9V 6F22)
•
1 pair of test leads
•
1 multi-function adaptor
•
1 protective case
•
1 instruction manual
4.3- Assembly
•
No assembly or adjustment is required by the user.
4.4- Switch On/Off
•
To switch on the meter, turn the power switch (3) to any functional position.
•
To switch off the meter, set the power switch (3) to “OFF” position.
V. OPERATION
5.1- Intended use
This multimeter is suitable for use with low energy circuits (below 500V RMS in AC or 500V in
DC). This is not intended for artisanal, commercial, professional and / or industrial use.
5.2- Operation
Display
a
Indicates the pressence of high
voltage input
b
Continuity beeper is on
c
Indicates negative reading
d
Display hold is active
e
Indicates the battery is low
f
Numerical value
Voltage measurement (V
⎓
or V~)
•
Connect the black test lead to the “COM” terminal, while the red test lead to the
“VΩmAhFE” terminal.
•
Turn the function switch (3) to appropriate voltage range position.
•
If the voltage to be measured is unknown, start the measurement with the highest voltage
range.
•
Connect the test leads across the source or load under measurement.
•
Turn on the power of the unit or circuit under measurement, the measured voltage value will
be displayed, along with the polarity.
d
a
b
c
e
f
