Fig.4
Fig.5
Fig.6
WARNING! CAUTION EXCESSIVE VIBRATION. STOP ENGINE IMMEDIATELY
Excessive vibration of blade means that it is not properly installed-stop engine immediately and
check blade. Blade not properly installed will cause injury.
4.3.6- Adjusting the line length
1. Your brush cutter is equipped with a semi- auto type nylon line head that allows the operator to
advance the line without stopping the engine.
2. When the line becomes short, lightly tap the head on the ground while running the engine at full
throttle.
3 Each time the head is bumped, the line advances about 25 mm.
4. For better effect, tap the head on bear ground or hard soil.
5. Avoid bumping in thick, tall grass as the engine may stall by overload.
4.4- Fuel
WARNING
!
1. Gasoline is highly flammable.
Avoid smoking or bringing any flame or sparks near fuel storage or refuel area.
2. Make sure to stop the engine and allow it cool before refueling the unit.
3. Select outdoor bare and open ground for fueling and move at least 3 m (10 ft) away from the
fueling point before starting the engine.
4. Use anti-oxidant added quality oil expressly labeled for air-cooled 2-cycle engine use
ASPEN
We recommend the use of Aspen2.
This ready-mixed petrol does not contain benzene or lead. It has a high octane index and the
advantage of always ensuring appropriate mixing ratio.
Aspen2 is suitable for 2-stroke engines and will contribute to a greater lifespan of your engine.
4.4.1- Recommended Mixing Ratio
Gasoline 25 : Oil 1
1. This engine is intended to operate on unleaded gasoline.
2. Make sure to use gasoline with a minimum octane number of 90RON
3. If you use a gasoline of a lower octane value than prescribed, there is a danger that the engine
temperature may rise and an engine problem such as piston seizing may consequently occur.
4. Poor quality gasoline or oils may damage sealing rings, fuel lines or fuel tank of the engine.
4.4.2- How to mix fuel
Page
42
/
49
