Problem Cause Solution
Problem
Cause
Solution
A.little or no material flow
1.nozzle clogged
2.suction tube clogged
3.material volume setting
turn too far to the right
4.suction tube loose
5.material is too thick
6.inconsistent paint
7.container is loose
1.clean
2.clean
3.turn to the left
4.insert
5.check viscosity
6.strain paint
7.tighten the container
B.material leaking
1.nozzle loose
2.nozzle worn
3.nozzle seal worn
4.material build-up on spray
pattern dial and nozzle
1.tighten
2.replace
3.replace
4.clean
C.atomization is too coarse
1.viacosity of material too high
2.material volume too large
3.nozzle clogged
4.too little pressure build-up
in container
1.thin
2.turn to the right
3.clean
4.tighten container
D.spray jet pulsates
1.material in container running out.
2.material is too thick
1.refill
2.check viscosity
E.pattern runs or sags
1.applying too much material
1.adjust material flow or increase movement of
spray gun
F.too much over-spray
1.gun too far from spray object
2.too much material applied
1.reduce distance
2.turn material volume setting to right
G.pattern is very light and splotchy
1.moving the spray gun too fast
1.adjust material flow or decrease movement of
spray gun
H.large cloud of paint
1. gun too close to surface
1.move gun away from surface
and reduce paint flow
VIII Warning!
1. Keep your workplace clean and tidy,never use the tool in hazardous areas that
contain flammable liquids,gasses or dusts.
2. Only use paints,solvents or other materials with a flash point of 73 °F(22C) or higher.
3. Never point the spray gun at other person or animal.In the event of an injury,seek immediate medical attention.
4. Always read the paint manufacturer's thinning instructions before use.
5. You must clean the spray gun thoroughly after each use.
6. Do not pull the power cord to move this tool.
