Page 23 / 37
- The product is intended for painting, varnishing works.
- The product is suitable for the use of water-based paint and oil paint.
- It is recommended to use environmentally friendly paints and solvents
- Only use the tool for its intended purpose. Do not use the product to do other things outside of the
described scope in this manual.
- Do not use the product for unsuitable purposes.
- The product is not intended for professional or industrial use.
5.2- NOT intended use
- The product is not intended for dispersion or latex products, acid coating products, for granular
products, corrosive products, caustic products ...
- The product is not intended for spraying plant protection products for the treatment of plants or
gardens.
- The product is not intended for spraying or application of paint, ink or other materials on human or
animal body.
5.3- Instructions d’utilisation
Remove the bucket.
Fill the bucket with the paint and dilute if necessary.
To start the gun: press the switch (position I).
Press the trigger to start spraying.
Adjust the jet effect (horizontal to vertical round flat) by adjusting the nozzle (Fig. 8).
Adjust the spray volume with the adjustment needle: turn to the left to reduce the volume, to the right
to increase (Fig. 9).
Adjust the spray width using the flow adjustment knob: turn the knob to the left to reduce the width,
to the right to increase it (Fig. 10).
Spray the work surface at 20-30cm away from the surface being sprayed and make long arm
movements rather than short wrist movements (Fig. 11).
To stop the gun: Turn the switch to the (0) Off position.
Tip: Before starting to spray the work surface, it is advisable to make an initial test by spraying a
small area.
Fig. 8
Fig. 9
Fig. 10 Fig. 11
