Page
41
/
45
2. Caution: After stopping the engine, the metal parts (e.g. muffler) are still hot.
Never touch the hot parts. Allow them to cool down before handling the machine.
3. Check there is no leakage of fuel or oil.
4. When transporting in a vehicle, make sure to firmly secure the product with no parts protruding outside the
vehicle to avoid a danger (e.g. fall, injury, damage; ...)
6.2- Cleaning
Clean plastic parts with a soft and clean cloth
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not use any caustic to clean the plastic parts.
Do not put or immerse machine in water or any other liquid and ensure that no water gets inside the machine or
engine. Do not clean the machine with running water or high pressure.
6.3- Troubleshooting
Problem
Possible cause
Possible solution
The engine does not start
Engine switch in OFF position.
Move switch to ON position
Fuel shut-off valve in OFF position.
Move valve to ON position
Fuel tank empty
Fill fuel tank with fuel
Spark plug disconnected.
Faulty spark plug.
Connect spark plug.
Replace spark plug.
Choke lever in wrong position
Adjust choke lever position
Emergency stop button in OFF position
Reset the button by rotating it right
until it pops up
Faulty engine
Contact customer service
The material to be shredded
is not pulling through the
unit
Blades jammed
Remove jammed material from the
Machine
Obstruction
Remove overly large branches
from the machine
Ensure hopper and discharge chute
are free of obstructions
Drive belt slipping
Adjust drive belt tension
Blades dull or damaged
Sharpen or replace blades
6.4- Storage
1. Clean the machine before storage.
Perform maintenance operations before storage.
For prolonged periods of storage, drain the oil and gasoline from the tanks, and lubricate the moving parts.
2. Remove the spark plug
3. The machine must be stored in a dry clean location, protected from frost and excessive heat.
Always lock up product and keep out of reach of children.
4. Do not place or store any object on top of the product.
6.5- Disposal
- Debris & remnants: do not throw with household rubbish or in the environment. Dispose of any debris and
remnants in rubbish collection centres or seek advice from your local municipality.
- Fuel and Oil: Before disposing of the product, drain the fuel and oil. Do not dispose of oil and fuel with
household waste, or in the environment, or in the gutter ... Take both the fuel and oil to a collection center or
recycling centre or ask your local municipality.
- Machine: do not dispose with household garbage. Do not throw into the environment.
Dispose of the product in a collection centre for waste or seek advice from your local municipality.
- Proceed with disposal of remnants, machine, accessories and packaging according to local regulations
regarding the protection of the environment.
Summary of Contents for Ribiland PRBVB196TH
Page 45: ...Page 45 45...