15. WARNING!
This machine produces an electromagnetic field during operation. This field may under some
circumstances interfere with active or passive medical implants. To reduce the risk of serious or
fatal injury, we recommend persons with medical implants to consult their physician and the
medical implant manufacturer before operating this machine.
16.
Wear hearing protection while operating the power tool.
The declared vibration total value has been measured in accordance with a standard test method and
may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
17. Warning: The vibration emission during actual use of the power tool can differ from the
declared total value depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an estimation
of exposure in the actual conditions of use (taking account of all parts of the operating cycle such as
the times when the tool is switched off and when it is running idle in addition to the trigger time).
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form
its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
4.2- Inserting and removing a socket
- To install a socket on the anvil (Fig 2):
Align the hole of the socket with the anvil and push
down firmly.
Ensure it is centered and properly fixed.
- To remove a socket from the anvil :
Pull socket out firmly
Fig. 2
4.3- Switch (Fig. 3)
To operate tool, press on switch (2) (Fig.1).
To stop tool, release switch.
The switch (2) has 2 positions :
- on top: (
R
) to reverse (go counter-clockwise)
- on bottom:
(F)
to go forward (clockwise)
Fig. 3
4.4- Torque adjustment (Fig.4)
- Press [a] to increase torque (max 350Nm in
Tightening mode and 500Nm in Loosening mode)
- Press [b] to decrease torque (min 150Nm in
Tightening mode)
Fig.4
