Installation
3
2.0
Installation
The IQ plus 2100 digital bench scale is designed for easy setup and installation. All models are pre-configured and
weight calibrated before shipment, with the load cell connected to the indicator. For simple, standalone scale
applications, hardware installation consists of attaching the indicator, mounting assembly, and bench scale, then leveling
the scale.
The IQ plus 2100 is weight calibrated before shipment from the factory, but recalibration at the installation site
is strongly recommended. Calibration by a certified scale technician is required for Legal-for-Trade
applications.
2.1
Unpacking and Assembly
Immediately after unpacking, visually inspect the IQ plus 2100 to ensure all components are included and
undamaged. The shipping carton should contain the indicator, the bench scale, the indicator mount (tilt stand,
column, or attachment bracket), this manual, and a parts kit. If any parts were damaged in shipment, notify Rice
Lake Weighing Systems and the shipper immediately.
The parts kit contains the items listed below:
• Capacity label (PN 42350)
• One grounding clamp (PN 53075), external tooth lock washer, (PN 15133), and kep nut (PN 14626) for
digital input or serial cable shield grounding against the enclosure.
• Two wing knobs with nylon washers for attaching the indicator to the mounting assembly, four rubber tilt
stand feet (for tilt stand option) or bench scale feet, jam nuts, lock washers, and cap screws (for column and
attachment bracket options).
To install, attach the mounting assembly to scale base, then assemble the indicator to the mounting assembly. Place
the bench scale in the desired location then lift off the scale platter and locate the bubble level. Adjust the corner
feet until the scale is level and all feet are in contact with the support surface. Tighten the jam nuts against the scale
to lock-in the level adjustment.
Plug power cord into power outlet to begin weighing.
The supply cord serves as the power disconnect for the IQ plus 2100. The power outlet supplying the
indicator must be installed near the unit and be easily accessible.
2.2
Factory Setup
The IQ plus 2100 is pre-configured and weight calibrated at the factory before shipment. Table 2-1 lists the default
graduations and count-by configuration for each scale capacity.
Scale Capacity
Count by
Configuration Parameters
DECPNT
DSPDIV
5 lb
0.001 lb
888.888
1D
10 lb
0.002 lb
888.888
2D
25 lb
0.005 lb
888.888
5D
50 lb
0.01 lb
8888.88
1D
100 lb
0.02 lb
8888.88
2D
2.5 Kg
0.0005 Kg
88.8888
5D
5 Kg
0.001 Kg
888.888
1D
10 Kg
0.002 Kg
888.888
2D
25 Kg
0.005 Kg
888.888
5D
50 Kg
0.01 Kg
8888.88
1D
All capacities are pre-configured for 5000 graduations
(GRADS parameter on CONFIG menu set to 5000).
Table 2-1. Default Scale Configurations
Note
WARNING
Note
Summary of Contents for IQ plus 2100
Page 2: ...IQ plus 2100 Digital Bench Scale Version 1 Installation Manual PN 53415 Rev A...
Page 3: ......
Page 42: ......
