Options
©
Rice Lake Weighing Systems
●
All Rights Reserved
61
16. Place the half clamp plate onto the studs, then place the clamp plate onto the studs with the step facing down and the
half plate nesting in the step of the clamp plate.
Figure 5-31. Place Half Clamp Down on Assembly
17. Press the assembly down and partially tighten the four nuts that hold the entire assembly in place. Once all the nuts
are started, tighten the nuts in a diagonal sequence until all the nuts are tight using a 7/16'' socket and torque wrench.
Tighten to 30 in/lb torque.
Figure 5-32. Tighten Up The Entire Assembly
18. When tightening plates make certain to allow enough slack in cable.
Figure 5-33. Keep Proper Amount of Slack in Cable
19. Close and latch printer cover.
20. Turn printer case on side to expose four mounting screws on bottom.
Half clamp plate
Clamp plate - note the
step for the half plate
Make certain slack is present
as shown in picture to allow
sealing of cable to print case
