RP-II-CS8G [C]
18
Sheet 7 of 16
www.richards-mfg.com
Product Family
CS8
9
.3
Inserting Hex Tool
A. Insert Hex tool (P620AT or equivalent
5
/
16
" hex tool) through loadbreak interface and engage fastener.
B. Slide fastener into forward position through lug hole (as shown in detail view).
!
WARNING: Fastener is factory-installed in a retracted position. The Fastener must be stroked into forward position. The female threaded
end of Fastener will then extend into the
15
/
16
" Threaded hole of the Lug.
!
WARNING: Confirm that fastener goes through lug hole as shown below.
Fastener in the retracted position
Fastener
Lug
Hex Tool
Push
Fastener stroked into forward position
through Lug Hole
Fastener through
Lug Hole
STEP 15-Mating Deadbreak Interface
STEP 14- Inserting Hex Tool
Product Family
R800
Installation Instructions
