北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd.
52
Forging ahead, create future together!
high
M216
Run the next line of G code after waiting until all the specified input signal logic
high
M217
Run the next line of G code after waiting until anyone of all the specified input
signal logic high
M220
Set Y1 logic low level
M221
Set Y1 logic high level
M222
Set Y2 logic low level
M223
Set Y2 logic high level
M224
Set Y3 logic low level
M225
Set Y3 logic high level
M226
Set Y4 logic low level
M227
Set Y4 logic high level
M350
Set the extension output logic low level
M351
Set the extension output logic high level
T
Tool function
S
Spindle speed
F
Feed rate
H
Tool length offset
9
Tool setting methods detailed explanation
The process of tool setting is process of setting work coordinate system specific location in the
machine tool coordinate system.
There are 3 ways for tool setting: Direct tool setting
,
Fixed calibration
and
Mobile calibration
9.1
Direct Tool Setting
Manually move down Z axis and make sure the tool bit touches the material surface. Of
course, user should reduce the motion speed of Z axis when the cutter is the most nearest the
plane.
To confirm the contact position between the tool and the workpiece by eye-measurement
or tool bit touch the workpiece surface. Then press “Z→0” to finish the tool setting.
