北京锐志天宏科技股份有限公司
Beijing RichAuto S&T Co., Ltd.
65
Forging ahead, create future together!
and then generate the correct one.
Hard limit triggering
1)
If the machine has connected with hard limit, the hard limit switch maybe damaged or the
voltage setup status on X6 is wrong.
2)
System has not connected with hard limit signal
：
Confirm whether connect other signal wire
to hard limit X6 port, if not, check voltage setup normal or not. If normal, user could go to
“MACHINE SETUP”-“Input Confi” and DISABLE X6 port, then go to “SYSTEM SETUP”- “wipe
cache”. If still can’t solve this problem, user can upgrade the system.
Z axis
（
spindle
）
fall down abnormally
（
too fast
）
and cause Z feed amount too much during
processing
1)
Z axis working speed exceed the fastest speed cause Z axis loses its steps when moving up. "
MACHINESETUP " - " Max Spd Limit "
，
set the safe speed.
2)
The coupling is loosen or transmission mechanism slipping. Re-adjustment the connecting
parts.
3)
The signal wire connected between the interface board and the motor driver has got
interference. Adjust the circuit.
4)
Processing file error. Check processing file, try to download the correct processing file to U
disk or handle internal.
5)
There is something wrong
（
plug loosen or wire damaged or wire diameter is too slimsy
）
with
the lines connecting Z axis motor and motor driver. Replace the lines.
Repeating the same processing file after returning back to the machine ZERO, Z axis cutting
depths are not as same as each other
1)
Machining table is uneven or processing object not firmly fixed, re-milling the machine table
to adjust the flatness.
2)
Z-axis origin detection switch repeat positioning accuracy error, causing Z axis homing error
each time. Replace a high-quality detection switch.
