Beijing RichAuto S&T Co., Ltd.
34
which also called ‘minimum feed rate’. Precision can reach to 0.001mm.When user switch to
“step” mode, and press the direction keys of X, Y, Z axis, machine will move by grid distance.
High speed mode setting is the same to low speed mode.
5.3.2 Manual processing mode
The system provides 3 manual movement modes: Conitnue, step, distance. User could press
“
” under manual mode to switch manual movement mode and view the current
movement mode through the screen bottom display status.
1)
Continue (Continuous motion mode)
No specific data control, user could press motion direction key of each axis
(
,
,
), the machine will move accordingly until the key is released. The
motion speed is determined by current manual speed mode.
2)
Step motion mode
In step mode, move 1 grid every half second. The grid distance is determined by the current
speed mode. It is suitable for precise adjusting the cutter orfine adjusting the location of the
mechanical coordinate.
3)
Distance motion mode
It runs a certain distance according to the setting. Press motion direction keys
(
,
,
),the machine will move accordingly.
Note: The movement will be carried out according to the current speed mode and the set
distance, it is not affect by the ‘grid’, so it will not stop on grid point. To change the distance value,
triple press “
” re-enter the ‘Distance’ value setting.
5.3.3 Manual testing input and output
Under the initial boot interface, that is screen displays as follow,
1 X 0.000
MAUN
1 Y
0.000
F 2
1 Z
0.000
L N1
Continue
